|
Turns out I was putting the second temperature commands afte... In forum PrusaSlicer |
7 months ago |
|
Start G-code Omitted from Sliced G-code 2.8.0 In forum PrusaSlicer |
7 months ago |
|
Thanks so much for the recommended settings and detailed exp... In forum PrusaSlicer |
1 year ago |
|
Interesting. I've read through several of these posts but ju... In forum PrusaSlicer |
1 year ago |
|
If I print with no infill the gap issue is mostly gone (thir... In forum PrusaSlicer |
1 year ago |
|
Extrusion gap near seam/deretraction In forum PrusaSlicer |
1 year ago |
|
Actually, I tried this again and it does fix it. I was getti... In forum PrusaSlicer |
1 year ago |
|
Ah, I see what you're saying about the infill, but one thing... In forum PrusaSlicer |
1 year ago |
|
Thanks. But why wouldn't the gap exist at the outer edge, un... In forum PrusaSlicer |
1 year ago |
|
Overhang Gap In forum PrusaSlicer |
1 year ago |
|
Confirmed, Prusa docs say this about the thin walls setting:... In forum PrusaSlicer |
3 years ago |
|
But the seam looks as smooth as can be on the Classic settin... In forum PrusaSlicer |
3 years ago |
|
Print just finished with 0.6mm nozzle QUALITY profile and al... In forum PrusaSlicer |
3 years ago |
|
Thanks. I did also notice some z artifacts on my print, whic... In forum PrusaSlicer |
3 years ago |
|
How could Arachne possibly be the default when it's so unrel... In forum PrusaSlicer |
3 years ago |
|
Attached zipped PrusaSlicer Project file
Box-Arachne... In forum PrusaSlicer |
3 years ago |
|
Seams Issue with Arachne In forum PrusaSlicer |
3 years ago |
|
@edg-engineering-2 I think I just accepted these gaps and di... In forum How do I print this? (Printing help) |
4 years ago |
|
@chocki Nice! Have you considered a volcano hot end upgrade?... In forum How do I print this? (Printing help) |
5 years ago |
|
@bobstro In the before gcode I turned down the "M221 S95" co... In forum How do I print this? (Printing help) |
5 years ago |
