Prusa3D Forum

Notifications

Clear all

chris.k26

Grupa: Zarejestrowany

Dołączył: 2019/01/20

Active Member

	I have added the PINDA wait command but haven't tried temper... In forum Hardware, firmware and software help	6 years temu
	Problem is back today. Just tried printing and the Z positio... In forum Hardware, firmware and software help	6 years temu
	Problem is back today. Just tried printing and the Z positio... In forum Hardware, firmware and software help	6 years temu
	Just posted the same thing on another thread. I was experien... In forum Hardware, firmware and software help	6 years temu
	I had the same problem. I switched off magnet compensation &... In forum Hardware, firmware and software help	6 years temu

Statystyki Forum

559 Fora

63.1 K Tematy

443.9 K Posty

22 Online

68.1 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte