Prusa3D Forum

Notifications

Clear all

chris.k26

Skupina: Registrovaný

Přidal se: 2019/01/20

Active Member

	I have added the PINDA wait command but haven't tried temper... In forum Hardware, firmware and software help	před 6 years
	Problem is back today. Just tried printing and the Z positio... In forum Hardware, firmware and software help	před 6 years
	Problem is back today. Just tried printing and the Z positio... In forum Hardware, firmware and software help	před 6 years
	Just posted the same thing on another thread. I was experien... In forum Hardware, firmware and software help	před 6 years
	I had the same problem. I switched off magnet compensation &... In forum Hardware, firmware and software help	před 6 years

Fórum Statistiky

566 Fóra

63.2 K Témata

444.2 K Příspěvky

21 Online

68.1 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed