|
Double check heatbed ground wire issue and confirming correc... In forum Hardware, firmware and software help |
5 years ago |
|
Ok cool. That makes sense. As far as cleaning off the heater... In forum Hardware, firmware and software help |
5 years ago |
|
Thanks for the reply. I read the nozzle changing instructio... In forum Hardware, firmware and software help |
5 years ago |
|
Filament leaking over eater block, but I can't screw the noz... In forum Hardware, firmware and software help |
5 years ago |
|
Just remembered to post back here.
I worked through with p... In forum Assembly and first prints troubleshooting |
7 years ago |
|
Ah cool. That makes sense. I'll try checking the sensor with... In forum Assembly and first prints troubleshooting |
7 years ago |
|
I'll give lowering the sensor a try.
I'm a bit confused th... In forum Assembly and first prints troubleshooting |
7 years ago |
|
Oh woah, the PINDA led never turns on. Is there a doc page o... In forum Assembly and first prints troubleshooting |
7 years ago |
|
Z axis hitting the print bed after calibration In forum Assembly and first prints troubleshooting |
7 years ago |
|
I'm glad you all found it helpful 🙂
It definitely felt lik... In forum General discussion, announcements and releases |
7 years ago |
|
Overview of troubleshooting my MK3 extrusion issues In forum General discussion, announcements and releases |
7 years ago |
|
Thanks for all of the tips!
And yeah, I'm def a bit more w... In forum Hardware, firmware and software help |
7 years ago |
|
Anyone know a nozzle variety pack that fits the MK3? In forum Hardware, firmware and software help |
7 years ago |
|
Thanks for the tip karl.w2. I'll give that a try.
Yeah, I'... In forum Hardware, firmware and software help |
7 years ago |
|
ColorPrint App doesn't work In forum Hardware, firmware and software help |
7 years ago |
