Prusa3D Forum

Notifiche

Cancella tutti

Chombie

Gruppo: Registrato

Registrato: 2020/11/16

Active Member

	@diem It is PLA. The only reason I had it so loose is becaus... Nel forum Hardware, firmware and software help	3 years fa
	@diem I have tried adjusting the idler. It is so loose the s... Nel forum Hardware, firmware and software help	3 years fa
	Need help with under extrusion! Nel forum Hardware, firmware and software help	3 years fa
	First layer calibration great, no other prints working Nel forum Hardware, firmware and software help	3 years fa
	@neophyl The nozzle is threaded all the way in. There must b... Nel forum Hardware, firmware and software help	4 years fa
	So I started with that advice and scrubbed down my buildplat... Nel forum Hardware, firmware and software help	4 years fa
	@tim-m30 Thanks for the reply! With this and the first respo... Nel forum Hardware, firmware and software help	4 years fa
	Changed nozzle now every print fails! Nel forum Hardware, firmware and software help	4 years fa

Statistiche Forum

559 Forum

62.9 K Discussioni

442.9 K Post

18 Online

67.7 K Utenti

Icone forum: Il forum non contiene post non letti Il forum contiene post non letti

Icone discussione: Nessuna Risposta Con risposte Attivo Hot In evidenza Disapprovato Risolto Privato Chiuso