Notifications
Clear all
Chombie
Groupe: Enregistré
A(ont) rejoint: 2020/11/16
Active Member
1
|
@diem It is PLA. The only reason I had it so loose is becaus... Dans le forum Hardware, firmware and software help |
il y a 3 years | |
|
@diem I have tried adjusting the idler. It is so loose the s... Dans le forum Hardware, firmware and software help |
il y a 3 years | |
|
Need help with under extrusion! Dans le forum Hardware, firmware and software help |
il y a 3 years | |
|
First layer calibration great, no other prints working Dans le forum Hardware, firmware and software help |
il y a 3 years | |
|
@neophyl The nozzle is threaded all the way in. There must b... Dans le forum Hardware, firmware and software help |
il y a 4 years | |
|
So I started with that advice and scrubbed down my buildplat... Dans le forum Hardware, firmware and software help |
il y a 4 years | |
|
@tim-m30 Thanks for the reply! With this and the first respo... Dans le forum Hardware, firmware and software help |
il y a 4 years | |
|
Changed nozzle now every print fails! Dans le forum Hardware, firmware and software help |
il y a 4 years |