|
Thanks! i did not know ! but sadly either give the same issu... In forum Hardware, firmware and software help |
6 years ago |
|
OK, so, I have made more tests, Loaded the 3.0.11 Firmware,... In forum Hardware, firmware and software help |
6 years ago |
|
It does happen when the speed is not too high ( actually it ... In forum Hardware, firmware and software help |
6 years ago |
|
I am using Pronterface, Using the LCD screen, the accelerati... In forum Hardware, firmware and software help |
6 years ago |
|
Ha sorry, it is 3.2.3. and i did the calibration in the ord... In forum Hardware, firmware and software help |
6 years ago |
|
Yes! I have the 1.3a and this is what's written in the LCD. ... In forum Hardware, firmware and software help |
6 years ago |
|
I am using PrusaSlicer to do the firmware update already 🙁 ... In forum Hardware, firmware and software help |
6 years ago |
|
so the reflash did not do much but I have noticed that it ga... In forum Hardware, firmware and software help |
6 years ago |
|
Hey! thanks for the answers! So... I did another reset, then... In forum Hardware, firmware and software help |
6 years ago |
|
I have figured something out!!I did a Printer full reset. an... In forum Hardware, firmware and software help |
6 years ago |
|
I agree, It hold the temp fine, for both bed and nozzle. I ... In forum Hardware, firmware and software help |
6 years ago |
|
Thanks! The last few seconds, it just happen that the bed is... In forum Hardware, firmware and software help |
6 years ago |
|
here is the video: In forum Hardware, firmware and software help |
6 years ago |
|
Y axis moves slightly with X axis movements Oo' In forum Hardware, firmware and software help |
6 years ago |
|
X axis squeaking noise. In forum Prusa i3 kit (Archive) |
8 years ago |
