Notifications
Clear all
Charles Coonz
Group: Registered
Joined: 2019/11/15
Active Member
1
|
Thanks, Any idea what printing surface and with what config ... In forum Hardware, firmware and software help |
5 years ago | |
|
I think you are right. I can see the left side of the print ... In forum Hardware, firmware and software help |
5 years ago | |
|
Axis Calibration Midprint In forum Hardware, firmware and software help |
5 years ago | |
| After doing some research i found out that this was due to e... | 5 years ago | |
| Printing keep clogging and failing | 5 years ago | |
| Printing keep clogging and failing | 5 years ago | |
| You where correct. There was a missasembly in the base belt ... | 5 years ago | |
| Also i printed a circle 8CM wide. was my first print (an esp... | 5 years ago | |
| Hello Zoltan, My model was Modeled via solidworks, exported ... | 5 years ago | |
| Circles Not perfect circles | 5 years ago |