ceryen.t – Aktywność – Prusa3D Forum

Notifications

Clear all

ceryen.t

Grupa: Zarejestrowany

Dołączył: 2016/11/09

Eminent Member

	I must have got lucky- I picked up both the RJZM-02-08 and t... In forum Hardware, firmware and software help	8 years temu
	ie Burning in was all the case. Sheesh, I could charge for ... In forum Others (Archive)	8 years temu
	Personally, I would be contacting support ASAP. If there is... In forum Others (Archive)	8 years temu
	As I mentioned in the improvements section, I came across: ... In forum Hardware, firmware and software help	8 years temu
	This smell, does it come from the printer when powered up an... In forum Others (Archive)	8 years temu
	Not plastic, ozone, or oil. It's darker, closer to a burnin... In forum Others (Archive)	8 years temu
	Power supply makes electrical smell In forum Others (Archive)	8 years temu
	I just ran some further experiments. I redid the full "Cali... In forum Others (Archive)	8 years temu
	I do get the congratulations that my axes are perpendicular.... In forum Others (Archive)	8 years temu
	I've determined that the cause of this issue is the X/Y skew... In forum Others (Archive)	8 years temu
	Clicking from X/Y-axis stepper motors when idle during print In forum Others (Archive)	8 years temu
	Seems that I misinterpreted this picture: I thought that t... In forum Prusa i3 kit (Archive)	8 years temu
	Looking at Thomas Sanlanderer's build video, it seems like t... In forum Prusa i3 kit (Archive)	8 years temu
	Extruder idler doesn't move back and forth once top screws a... In forum Prusa i3 kit (Archive)	8 years temu

Strona 2 / 2 Wstecz

Statystyki Forum

559 Fora

63 K Tematy

443.6 K Posty

20 Online

67.9 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte