Notifications
Clear all
CaseyDanger
Groupe: Enregistré
A(ont) rejoint: 2023/12/21
Active Member
1
|
That looks a lot like the first layer I was getting after up... Dans le forum Assembly and first prints troubleshooting |
il y a 11 months | |
|
One more update: When I ordered a replacement thermistor I t... Dans le forum Hardware, firmware and software help |
il y a 11 months | |
|
I'm getting this same noise on a MK3s upgraded to a MK4! Las... Dans le forum Hardware, firmware and software help |
il y a 11 months | |
|
After printing a few more items, I'm inclined to agree. Sinc... Dans le forum Hardware, firmware and software help |
il y a 11 months | |
|
First layer consistently over-extruded, but good print overa... Dans le forum Hardware, firmware and software help |
il y a 11 months |