Avisos
Vaciar todo
CaseyDanger
Grupo: Registrado
Registrado: 2023/12/21
Active Member
1
That looks a lot like the first layer I was getting after up... En el foro Assembly and first prints troubleshooting |
hace 11 months | |
One more update: When I ordered a replacement thermistor I t... En el foro Hardware, firmware and software help |
hace 11 months | |
I'm getting this same noise on a MK3s upgraded to a MK4! Las... En el foro Hardware, firmware and software help |
hace 11 months | |
After printing a few more items, I'm inclined to agree. Sinc... En el foro Hardware, firmware and software help |
hace 11 months | |
First layer consistently over-extruded, but good print overa... En el foro Hardware, firmware and software help |
hace 11 months |