Čeština
Fóra
Uživatelé
Cannikin
Aktivita
 
Notifications
Clear all
Cannikin
Cannikin
Skupina: Registrovaný
Přidal se: 2023/11/22
Active Member
1
Profile Aktivita
Oh snap, mine just worked after cycling power as well! That'...

In forum General discussion, announcements and releases

 před 2 years
Me too, but when that failed I thought maybe a reboot would ...

In forum General discussion, announcements and releases

 před 2 years
I just finished the 6.0.0 upgrade on my MK4 and I can't get ...

In forum General discussion, announcements and releases

 před 2 years
Actual image:

In forum Assembly and first prints troubleshooting

 před 2 years
Stringing is 90-95% gone at 210° with the new thermistor! I ...

In forum Assembly and first prints troubleshooting

 před 2 years
Got my XL thermistor (blue wires with orange heat shrink) an...

In forum Assembly and first prints troubleshooting

 před 2 years
Got my XL thermistor (blue wires with orange heat shrink) an...

In forum Assembly and first prints troubleshooting

 před 2 years
Support is sending me an XL thermistor! They said my resista...

In forum Assembly and first prints troubleshooting

 před 2 years
I'm talking to support right now, trying to see if I can get...

In forum Assembly and first prints troubleshooting

 před 2 years
The temp tower failed at 160°, but even at 165° I still had ...

In forum Assembly and first prints troubleshooting

 před 2 years
Printing a temperature tower, I still get microscopic string...

In forum Assembly and first prints troubleshooting

 před 2 years
I installed 2.7.0-rc1 of Prusa Slicer and the 5.1.0 beta fir...

In forum Assembly and first prints troubleshooting

 před 2 years
I'm also on the whispy strings train! I thought maybe I got ...

In forum Assembly and first prints troubleshooting

 před 2 years
Share: