Notifications
Clear all
Calin
Skupina: PrusaLink-beta
Přidal se: 2018/07/26
Název: Member
|
Thanks, everyone for your suggestions! (not really) 🤣 After... In forum Hardware, firmware and software help |
před 5 years | |
|
Gears slipping during printing and hard to move by hand. In forum Hardware, firmware and software help |
před 5 years | |
|
Having the same issue, from what I've tested it does seem to... In forum Hardware, firmware and software help |
před 5 years | |
|
look if the SD slot is clean. i had some plastic from an old... In forum Hardware, firmware and software help |
před 6 years | |
|
No longer detecting SD Card while on In forum Hardware, firmware and software help |
před 6 years | |
| Alright thanks mate, will give it a shot. | před 6 years | |
| Support layer too strong | před 6 years |