|
It was not printing for a few days, had zero in Queue, and t... In forum Bugs & Errors |
8 months ago |
|
I have been printing all day (manually deleting each printed... In forum Bugs & Errors |
8 months ago |
|
Not for me 🙁 In forum Bugs & Errors |
8 months ago |
|
PSU Quick Release connector is a good idea; however, unless ... In forum General discussion, announcements and releases |
8 months ago |
|
Printer: MK4 Printer Firmware: 6.0.0+14794 Printer UUID: 219... In forum Bugs & Errors |
8 months ago |
|
Interesting, I did not notice, that heater that come with E3... In forum Others (Archive) |
7 years ago |
|
In the end everything was so in plastic, that easiest (and l... In forum Others (Archive) |
7 years ago |
|
Interesting, I was printing fine before that Raft incident.
... In forum Others (Archive) |
7 years ago |
|
You can see relatively small blob on top of the heater block... In forum Others (Archive) |
7 years ago |
|
at 280, higher I get thermal runaway error.
Just to confirm ... In forum Others (Archive) |
7 years ago |
|
Interesting, if 50% is "finished quality", what will be Dama... In forum Others (Archive) |
7 years ago |
|
Max layer height and too high layer height In forum Others (Archive) |
7 years ago |
|
Material just flows from nozzle 🙁 In forum Others (Archive) |
7 years ago |
