Prusa3D Forum

Notifications

Clear all

BullDog8484

Groupe: Enregistré

A(ont) rejoint: 2025/09/15

Active Member

	A little over 100 hours of printing on 6.4.1 Beta. Multiple... Dans le forum General discussion, announcements and releases	il y a 3 weeks
	So, yeah, of my two XL's, one was completely stable on 6.4.0... Dans le forum General discussion, announcements and releases	il y a 3 weeks
	Testing 6.4.1RC on one of my two XL's. So far, so good. Ti... Dans le forum General discussion, announcements and releases	il y a 4 weeks
	Been testing the RC2 firmware on one of my XL's since its re... Dans le forum General discussion, announcements and releases	il y a 4 months
	I’ve run about three days’ worth of printing with multiple j... Dans le forum General discussion, announcements and releases	il y a 4 months
	So far so good. But I'm only on my second print. Dans le forum General discussion, announcements and releases	il y a 4 months
	Rolling back to 6.2.6 on both XL's now. I tried over 20 pri... Dans le forum General discussion, announcements and releases	il y a 6 months
	Several head crashes both at the beginning of prints or at t... Dans le forum General discussion, announcements and releases	il y a 7 months

Statistiques du forum

598 Forums

71.1 K Sujets

498.5 K Messages

11 En-ligne

82.5 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé