Notifications
Clear all
bryn51
bryn51
Skupina: Registrovaný
Přidal se: 2022/04/25
Estimable Member
4
What you say has some merit.I agree on the need for a dual e...

In forum General discussion, announcements and releases

před 3 weeks
Clearly you are not understanding the cause of the issue, an...

In forum Hardware, firmware and software help

před 3 weeks
Yeah sure. But at least they can easily test materials they ...

In forum General discussion, announcements and releases

před 4 weeks
It seems one thing its NOT going to be good for, is printing...

In forum General discussion, announcements and releases

před 4 weeks
Yeah. I understand why the printer needs to move the bed ha...

In forum Hardware, firmware and software help

před 2 months
To dare inly 2 quick fixes have cone forward 1-. use a thin ...

In forum General discussion, announcements and releases

před 3 months
Hey @BobCollins unlike some others, I just hunkered down and...

In forum General discussion, announcements and releases

před 3 months
Yeah thats not it. I did as you suggest today on a print, a...

In forum Hardware, firmware and software help

před 3 months
Unsure. Most people thought that the graphics progress disp...

In forum Hardware, firmware and software help

před 3 months
Yeah,We often see on Facebook photos of different issues on ...

In forum Input Shaper (MK4)

před 3 months
It works well when you upload from Prusaslicer which is what...

In forum General discussion, announcements and releases

před 3 months
Read the thread. many have this issue. it can be fixed by al...

In forum General discussion, announcements and releases

před 3 months
Check the orientation of the y axis idler holder. the slot f...

In forum General discussion, announcements and releases

před 3 months
Here is something else I found on y axis only yesterday. I...

In forum General discussion, announcements and releases

před 3 months
The release notes are not very good. I have complained to pr...

In forum General discussion, announcements and releases

před 3 months
It is in the release notes. You just have to read between t...

In forum Hardware, firmware and software help

před 4 months
The general case is that firmware release notes ought to be ...

In forum General discussion, announcements and releases

před 4 months
Using "Cancel Object" relies upon a specific settings in Pru...

In forum General discussion, announcements and releases

před 4 months
Of course you are correct, and if you read thru the posts yo...

In forum Hardware, firmware and software help

před 4 months
I tried what you said, and after a couple of attempts, your ...

In forum Hardware, firmware and software help

před 4 months
Stránka 1 / 6
Share: