Prusa3D Forum

Notifiche

Cancella tutti

Bryan_K

Gruppo: Registrato

Registrato: 2023/09/13

Active Member

	So it happened again, this time during a short print. Differ... Nel forum How do I print this? (Printing help)	2 months fa
	I think there were only a few lines of infill on the lower p... Nel forum How do I print this? (Printing help)	2 months fa
	There was probably no power fail, I don't know if the printe... Nel forum How do I print this? (Printing help)	2 months fa
	Darn that's devious, I see the proper image. Thanks, I'll tr... Nel forum How do I print this? (Printing help)	2 months fa
	How did that happen? Nel forum How do I print this? (Printing help)	2 months fa
	Thanks for your reply. Unfortunately I can't use the text mo... Nel forum How do I print this? (Printing help)	4 months fa
	Printing text Nel forum How do I print this? (Printing help)	4 months fa
	So I bought some BVOH and made some tests. I was able to pri... Nel forum How do I print this? (Printing help)	7 months fa
	Oh so you mean that the XL doesn't probe with a magnetic sen... Nel forum How do I print this? (Printing help)	7 months fa
	Printing on glass Nel forum How do I print this? (Printing help)	7 months fa
	Have you also tried PVA and if so how do the two compare? Do... Nel forum How do I print this? (Printing help)	7 months fa
	In cas anyone has the same problem, I've been able to get PV... Nel forum How do I print this? (Printing help)	7 months fa
	Need help with soluble supports Nel forum How do I print this? (Printing help)	7 months fa
	How do I get out of this mess? Nel forum Hardware, firmware and software help	2 years fa

Statistiche Forum

595 Forum

68.8 K Discussioni

481.2 K Post

15 Online

77.3 K Utenti

Icone forum: Il forum non contiene post non letti Il forum contiene post non letti

Icone discussione: Nessuna Risposta Con risposte Attivo Hot In evidenza Disapprovato Risolto Privato Chiuso