|
I don't think one can get enough detail using sand casting. ... Im Forum Hardware, firmware and software help |
Vor 1 day |
|
I agree that FDM printing is amazing. But those layer lines... Im Forum Hardware, firmware and software help |
Vor 1 day |
|
No thanks on printing much in the way of exotics. My printi... Im Forum Hardware, firmware and software help |
Vor 1 day |
|
Reading on various machining forums, the consensus is that D... Im Forum Hardware, firmware and software help |
Vor 2 days |
|
Suppose you are right about the friction. I'll try some kin... Im Forum Hardware, firmware and software help |
Vor 2 days |
|
I've never heard of needing to lubricate delrin, never mind ... Im Forum Hardware, firmware and software help |
Vor 2 days |
|
Sorry if I was crabby the other day, but a 30 minute print t... Im Forum Hardware, firmware and software help |
Vor 2 days |
|
Strangely, when I powered up the Core 1+ today, it was quiet... Im Forum Hardware, firmware and software help |
Vor 3 days |
|
Z homing error Im Forum Hardware, firmware and software help |
Vor 3 days |
|
Adding oil is definitely worth a try. At that point, I'd al... Im Forum Hardware, firmware and software help |
Vor 7 days |
|
Anyone know where I could find a replacment fan for the powe... Im Forum Hardware, firmware and software help |
Vor 7 days |
|
A smaller amount of RMS surface deviation reveals the line a... Im Forum Hardware, firmware and software help |
Vor 2 weeks |
|
Might be a coincidence, but the ring defect mimics (roughly)... Im Forum Hardware, firmware and software help |
Vor 2 weeks |
|
Might be a coincidence, but the ring defect mimics (roughly)... Im Forum Hardware, firmware and software help |
Vor 2 weeks |
|
I can report that using a 2mm radius fillet at the base didn... Im Forum Hardware, firmware and software help |
Vor 2 weeks |
|
For any filament, do not trust that it will be dry out of th... Im Forum General discussion, announcements and releases |
Vor 2 weeks |
|
I haven't noticed any feeding issues. Don't think the Bowde... Im Forum Hardware, firmware and software help |
Vor 2 weeks |
|
I can put in a fillet of 2mm easily on the bottom piece. Th... Im Forum Hardware, firmware and software help |
Vor 2 weeks |
|
If anything, I'm slightly under extruding, at least for 0.2m... Im Forum Hardware, firmware and software help |
Vor 2 weeks |
|
Yes, I can make a filleted transition in the bottom, rather ... Im Forum Hardware, firmware and software help |
Vor 2 weeks |
