Prusa3D Forum

Notifications

Clear all

Bruce B

Groupe: Enregistré

A(ont) rejoint: 2018/02/22

Active Member

	Under extruding Dans le forum Hardware, firmware and software help	il y a 4 years
	As best I can tell the FINDA reads N/A at some points by des... Dans le forum Hardware, firmware and software help	il y a 4 years
	Replaced the FINDA sensor and it made no difference. I’ve al... Dans le forum Hardware, firmware and software help	il y a 4 years
	Thanks for the confirmation that it’s not just me. I’ve orde... Dans le forum Hardware, firmware and software help	il y a 4 years
	PINDA NA and Selector motor hot Dans le forum Hardware, firmware and software help	il y a 4 years
	I have the same issue. All my user presets disappeared and w... Dans le forum PrusaSlicer	il y a 4 years
	Thanks - I tried the squares test. The underside of the squa... Dans le forum Assembly and first prints troubleshooting	il y a 7 years
	Thanks for the ideas. The y-axis rails are in place, but it ... Dans le forum Assembly and first prints troubleshooting	il y a 7 years
	Strands of filament all over left half of layer Dans le forum Assembly and first prints troubleshooting	il y a 7 years

Statistiques du forum

565 Forums

63.6 K Sujets

446.4 K Messages

22 En-ligne

69.1 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé