Notifications
Clear all
Bruce B
Skupina: Registrovaný
Přidal se: 2018/02/22
Active Member
1
|
Under extruding In forum Hardware, firmware and software help |
před 5 years | |
|
As best I can tell the FINDA reads N/A at some points by des... In forum Hardware, firmware and software help |
před 5 years | |
|
Replaced the FINDA sensor and it made no difference. I’ve al... In forum Hardware, firmware and software help |
před 5 years | |
|
Thanks for the confirmation that it’s not just me. I’ve orde... In forum Hardware, firmware and software help |
před 5 years | |
|
PINDA NA and Selector motor hot In forum Hardware, firmware and software help |
před 5 years | |
|
I have the same issue. All my user presets disappeared and w... In forum PrusaSlicer |
před 5 years | |
| Thanks - I tried the squares test. The underside of the squa... | před 7 years | |
| Thanks for the ideas. The y-axis rails are in place, but it ... | před 7 years | |
| Strands of filament all over left half of layer | před 7 years |