Notifications
Clear all
brian.p
Grupa: Zarejestrowany
Dołączył: 2017/01/18
Active Member
1
| actually the part is still loose, i managed to sand off the ... | 6 years temu | |
| i figured it out, because i had to print in PETG, my 1st lay... | 6 years temu | |
| I just reprinted, still very loose. unable to tighten down e... | 6 years temu | |
| No on the scaling. I am going to re-print and verify. I just... | 6 years temu | |
| MK2s PETG Printed Parts | 6 years temu | |
|
60C. I'm going to try an enclosure next In forum Others (Archive) |
7 years temu | |
|
Thermal Runaway & Cooling In forum Others (Archive) |
7 years temu |