Notifications
Clear all
brian.p
Skupina: Registrovaný
Přidal se: 2017/01/18
Active Member
1
actually the part is still loose, i managed to sand off the ... | před 6 years | |
i figured it out, because i had to print in PETG, my 1st lay... | před 6 years | |
I just reprinted, still very loose. unable to tighten down e... | před 6 years | |
No on the scaling. I am going to re-print and verify. I just... | před 6 years | |
MK2s PETG Printed Parts | před 6 years | |
60C. I'm going to try an enclosure next In forum Others (Archive) |
před 7 years | |
Thermal Runaway & Cooling In forum Others (Archive) |
před 7 years |