Notifiche
Cancella tutti
Bret O
Gruppo: Registrato
Registrato: 2018/09/24
Active Member
1
|
GOO file format from Elegoo Nel forum PrusaSlicer |
2 years fa | |
| Commnads for filament unload and load sequence | 3 years fa | |
|
Elephant foot on top layer Nel forum PrusaSlicer |
4 years fa | |
|
@Swiss_Cheese I wasn't aware of that setting to pop out the ... Nel forum PrusaSlicer |
4 years fa | |
|
I saw those Note sections but I thought they would save with... Nel forum PrusaSlicer |
4 years fa | |
|
PrusaSlicer - Is there a comments area in 3MF or STL Nel forum PrusaSlicer |
4 years fa | |
| @matt-14 Good catch Matt. I noticed the length difference b... | 5 years fa | |
| @joantabb As I stated originally my S kit had a red filament... | 5 years fa | |
| @area51 I haven't started the MK3S upgrade yet. I was thinki... | 5 years fa | |
| MK3S to MK3S+ upgrade - Super PINDA only? | 5 years fa | |
|
@michael-19 Any update on this?.... I have be looking at res... Nel forum Hardware, firmware and software help |
5 years fa |