Avisos
Vaciar todo
Bret O
Grupo: Registrado
Registrado: 2018/09/24
Active Member
1
|
GOO file format from Elegoo En el foro PrusaSlicer |
hace 1 year | |
| Commnads for filament unload and load sequence | hace 2 years | |
|
Elephant foot on top layer En el foro PrusaSlicer |
hace 3 years | |
|
@Swiss_Cheese I wasn't aware of that setting to pop out the ... En el foro PrusaSlicer |
hace 3 years | |
|
I saw those Note sections but I thought they would save with... En el foro PrusaSlicer |
hace 3 years | |
|
PrusaSlicer - Is there a comments area in 3MF or STL En el foro PrusaSlicer |
hace 3 years | |
| @matt-14 Good catch Matt. I noticed the length difference b... | hace 4 years | |
| @joantabb As I stated originally my S kit had a red filament... | hace 4 years | |
| @area51 I haven't started the MK3S upgrade yet. I was thinki... | hace 4 years | |
| MK3S to MK3S+ upgrade - Super PINDA only? | hace 4 years | |
|
@michael-19 Any update on this?.... I have be looking at res... En el foro Hardware, firmware and software help |
hace 4 years |