|
Excellent In forum User mods - OctoPrint, enclosures, nozzles, ... |
6 years ago |
|
Yes, and it is working just not sure if it really needs the ... In forum User mods - OctoPrint, enclosures, nozzles, ... |
6 years ago |
|
Install heat sink on Raspberry Pi for Octoprint? In forum User mods - OctoPrint, enclosures, nozzles, ... |
6 years ago |
|
I ordered a lot of different nozzles from E3D, so I'll play ... In forum How do I print this? (Printing help) |
6 years ago |
|
I finally was able to print it. I switched back to the brass... In forum How do I print this? (Printing help) |
6 years ago |
|
@Joan, thanks for the tips, I made it further than I have be... In forum How do I print this? (Printing help) |
6 years ago |
|
This is what I get when I change the brim to 10mm. All of th... In forum How do I print this? (Printing help) |
6 years ago |
|
So it is possible to print 🙂
How did you get the brim to g... In forum How do I print this? (Printing help) |
6 years ago |
|
I should shoot for next Halloween rather than this one. It w... In forum How do I print this? (Printing help) |
6 years ago |
|
I tried:
Retraction Length - 0.9, 1.2, 1.4
Retraction Speed... In forum How do I print this? (Printing help) |
6 years ago |
|
I tried the new INI settings, but that did not really help. ... In forum How do I print this? (Printing help) |
6 years ago |
|
A dirty base is not the issue, and I have cleaned it so many... In forum How do I print this? (Printing help) |
6 years ago |
|
Ghost comes unstuck from the bed during printing In forum How do I print this? (Printing help) |
6 years ago |
