|
Excellent Im Forum User mods - OctoPrint, enclosures, nozzles, ... |
Vor 6 years |
|
Yes, and it is working just not sure if it really needs the ... Im Forum User mods - OctoPrint, enclosures, nozzles, ... |
Vor 6 years |
|
Install heat sink on Raspberry Pi for Octoprint? Im Forum User mods - OctoPrint, enclosures, nozzles, ... |
Vor 6 years |
|
I ordered a lot of different nozzles from E3D, so I'll play ... Im Forum How do I print this? (Printing help) |
Vor 6 years |
|
I finally was able to print it. I switched back to the brass... Im Forum How do I print this? (Printing help) |
Vor 6 years |
|
@Joan, thanks for the tips, I made it further than I have be... Im Forum How do I print this? (Printing help) |
Vor 6 years |
|
This is what I get when I change the brim to 10mm. All of th... Im Forum How do I print this? (Printing help) |
Vor 6 years |
|
So it is possible to print 🙂
How did you get the brim to g... Im Forum How do I print this? (Printing help) |
Vor 6 years |
|
I should shoot for next Halloween rather than this one. It w... Im Forum How do I print this? (Printing help) |
Vor 6 years |
|
I tried:
Retraction Length - 0.9, 1.2, 1.4
Retraction Speed... Im Forum How do I print this? (Printing help) |
Vor 6 years |
|
I tried the new INI settings, but that did not really help. ... Im Forum How do I print this? (Printing help) |
Vor 6 years |
|
A dirty base is not the issue, and I have cleaned it so many... Im Forum How do I print this? (Printing help) |
Vor 6 years |
|
Ghost comes unstuck from the bed during printing Im Forum How do I print this? (Printing help) |
Vor 6 years |
