Avisos
Vaciar todo
BravoZulu
Grupo: Registrado
Registrado: 2019/11/01
Active Member
1
|
@dvoita Hello, Yes, after replacing the Buddy Control Board ... En el foro Hardware, firmware and software help |
hace 5 years | |
|
So, had a nice chat. After briefly stating the problem, resu... En el foro Hardware, firmware and software help |
hace 5 years | |
|
@crawlerin Yes, of course I disassembled all components. As ... En el foro Hardware, firmware and software help |
hace 5 years | |
|
@bobcousins Hi. Yes, Motor inclusive cable is new.Swapping S... En el foro Hardware, firmware and software help |
hace 5 years | |
|
Extruder not working properly (no clogging, no blocking) En el foro Hardware, firmware and software help |
hace 5 years | |
| Hi, until today I was „read only“ here in the forum. I just ... | hace 6 years |