Prusa3D Forum

Notifications

Clear all

BravoZulu

Skupina: Registrovaný

Přidal se: 2019/11/01

Active Member

	@dvoita Hello, Yes, after replacing the Buddy Control Board ... In forum Hardware, firmware and software help	před 4 years
	So, had a nice chat. After briefly stating the problem, resu... In forum Hardware, firmware and software help	před 4 years
	@crawlerin Yes, of course I disassembled all components. As ... In forum Hardware, firmware and software help	před 4 years
	@bobcousins Hi. Yes, Motor inclusive cable is new.Swapping S... In forum Hardware, firmware and software help	před 4 years
	Extruder not working properly (no clogging, no blocking) In forum Hardware, firmware and software help	před 4 years
	Hi, until today I was „read only“ here in the forum. I just ... In forum General discussion, announcements and releases	před 5 years

Fórum Statistiky

566 Fóra

63.2 K Témata

444.4 K Příspěvky

20 Online

68.1 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed