Notifications
Clear all
Brandon
Skupina: Registrovaný
Přidal se: 2021/09/04
Active Member
1
| Update for my case. I contacted support, and after some trou... | před 1 year | |
| I wonder if it might help if the firmware could perhaps be p... | před 1 year | |
| @lfachaux - The ribbon cable's around 20" long. | před 1 year | |
| @lfachaux - the ribbon is 30mm wide. It divides after a cent... | před 1 year | |
| oh no | před 1 year | |
| First boot - LCD fails shortly after boot | před 1 year | |
|
The critical bit of gcode is making sure that the file ends ... In forum PrusaSlicer |
před 3 years | |
|
The good news is that I did get my Prusa plotting! . The ba... In forum PrusaSlicer |
před 3 years | |
|
Answering my own question, I found the relevant bit in the s... In forum PrusaSlicer |
před 3 years | |
|
Simple gcode files produce error: "The selected file: does n... In forum PrusaSlicer |
před 3 years |