|
I do tend to tighten the zip ties up as much as I can but ma... In forum Hardware, firmware and software help |
2 years ago |
|
Sorry I should have said that I have been packing the bearin... In forum Hardware, firmware and software help |
2 years ago |
|
X-axis bearings failure and scored rods again In forum Hardware, firmware and software help |
2 years ago |
|
Handy tip for the next time I have to do this. Thanks. In forum Hardware, firmware and software help |
2 years ago |
|
I suspect that "Galaxy" can not be protected. There are quit... In forum General discussion, announcements and releases |
2 years ago |
|
On the Mk3S+ the issue of the button press not being registe... In forum Hardware, firmware and software help |
2 years ago |
|
I was thinking about that but my text is on the same layers ... In forum PrusaSlicer |
2 years ago |
|
Arachne does seem to help a lot with bulge but it is causing... In forum PrusaSlicer |
2 years ago |
|
Sorry @rinkel, I seem to have got a bit confused now... Are ... In forum PrusaSlicer |
2 years ago |
|
Yes my model was bulge-free when I tried it in Cura. It othe... In forum PrusaSlicer |
2 years ago |
|
"Detect thin walls" slightly improved the bulge but broke th... In forum PrusaSlicer |
2 years ago |
|
I tried copying some of the other default Cura settings to P... In forum PrusaSlicer |
2 years ago |
|
The bulge has been a non-stop problem for me for most of my ... In forum PrusaSlicer |
2 years ago |
|
I had an Ender 3 for some time and eventually purchased a MK... In forum General discussion, announcements and releases |
2 years ago |
|
I think that this is normal with the smooth sheet (including... In forum Hardware, firmware and software help |
2 years ago |
|
I doubt that a third party (the Etsy seller) would have been... In forum General discussion, announcements and releases |
3 years ago |
|
I second what @Diem says. Also, sometimes you get marks on t... In forum Hardware, firmware and software help |
3 years ago |
|
Yes there is a lot of stolen stuff on the Internet being sol... In forum General discussion, announcements and releases |
3 years ago |
|
It could be poor internal lubrication of the bearings, possi... In forum Assembly and first prints troubleshooting |
3 years ago |
