Prusa3D Forum

Notifications

Clear all

Boozebeard

Grupa: Zarejestrowany

Dołączył: 2021/02/21

Active Member

	UH, so right after get it extruding properly I notice lots o... In forum How do I print this? (Printing help)	4 years temu
	I fixed it! After un jamming the filament I noticed that the... In forum How do I print this? (Printing help)	4 years temu
	Cleaned out the break but it didn't help :(I think there's s... In forum How do I print this? (Printing help)	4 years temu
	Ok, I'm pretty sure the issue is filament in my heatbreak. W... In forum How do I print this? (Printing help)	4 years temu
	The first layer seems to go down much better, it's when it s... In forum How do I print this? (Printing help)	4 years temu
	The only upgrade was the superPINDA, everything else was sta... In forum How do I print this? (Printing help)	4 years temu
	Rough, patchy, uneven layers In forum How do I print this? (Printing help)	4 years temu

Statystyki Forum

566 Fora

63.1 K Tematy

444.1 K Posty

23 Online

68 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte