Prusa3D Forum

Notifications

Clear all

Boozebeard

Skupina: Registrovaný

Přidal se: 2021/02/21

Active Member

	UH, so right after get it extruding properly I notice lots o... In forum How do I print this? (Printing help)	před 4 years
	I fixed it! After un jamming the filament I noticed that the... In forum How do I print this? (Printing help)	před 4 years
	Cleaned out the break but it didn't help :(I think there's s... In forum How do I print this? (Printing help)	před 4 years
	Ok, I'm pretty sure the issue is filament in my heatbreak. W... In forum How do I print this? (Printing help)	před 4 years
	The first layer seems to go down much better, it's when it s... In forum How do I print this? (Printing help)	před 4 years
	The only upgrade was the superPINDA, everything else was sta... In forum How do I print this? (Printing help)	před 4 years
	Rough, patchy, uneven layers In forum How do I print this? (Printing help)	před 4 years

Fórum Statistiky

566 Fóra

63.1 K Témata

444.1 K Příspěvky

23 Online

68 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed