Actividad
 
Avisos
Vaciar todo
bob.s
bob.s
Grupo: Registrado
Registrado: 2016/11/02
Eminent Member
2
Just adding to what nikolai and PJR have stated:.. I get al...

En el foro Others (Archive)

hace 6 years
I am trying to figure out the maximum print speed for PLA on...

En el foro Others (Archive)

hace 6 years
So, finally getting back to this. I printed mine standing u...

En el foro Awesome prints (Hall Of Fame)

hace 8 years
Very helpful. Thank you.

En el foro Assembly and first prints troubleshooting

hace 8 years
Thanks for you suggestions. I have changed filament with no...

En el foro Others (Archive)

hace 8 years
Extrusion failure

En el foro Others (Archive)

hace 8 years
Print Challenge

En el foro Awesome prints (Hall Of Fame)

hace 8 years
Thanks everyone! I feel really dumb. 😳 It was the li...

En el foro Print tips (Archive)

hace 8 years
I can't print Marvin anymore (Mk2)

En el foro Print tips (Archive)

hace 8 years
In an enclosure? No. There is no enclosure, but also no dra...

En el foro Others (Archive)

hace 8 years
Flaky bed temperature

En el foro Others (Archive)

hace 8 years
Good idea. By the way if you are a developer on the Prusa...

En el foro Improvements (Archive)

hace 8 years
For anyone following this thread, there's a happy ending! I...

En el foro Improvements (Archive)

hace 8 years
Initial Z coordinate

En el foro Prusa i3 kit (Archive)

hace 8 years
I used a PT100 temperature table that I found here: to do t...

En el foro Improvements (Archive)

hace 8 years
I have spent quite a bit of time figuring out about PT100 an...

En el foro Improvements (Archive)

hace 8 years
Peter, thanks for the confirmation that I am not alone here....

En el foro Software (Archive)

hace 8 years
Sorry if I offended anyone. What I observed was a substan...

En el foro Software (Archive)

hace 8 years
Hello, I too am trying to interface a PT100 to the Rambo, bu...

En el foro Improvements (Archive)

hace 8 years
I figured this out. I was using firmware that I built from ...

En el foro Assembly and first prints troubleshooting

hace 8 years
Página 1 / 2
Compartir: