Prusa3D Forum

Notifications

Clear all

bob.s

Groupe: Enregistré

A(ont) rejoint: 2016/11/02

Eminent Member

	Just adding to what nikolai and PJR have stated:.. I get al... Dans le forum Others (Archive)	il y a 6 years
	I am trying to figure out the maximum print speed for PLA on... Dans le forum Others (Archive)	il y a 6 years
	So, finally getting back to this. I printed mine standing u... Dans le forum Awesome prints (Hall Of Fame)	il y a 8 years
	Very helpful. Thank you. Dans le forum Assembly and first prints troubleshooting	il y a 8 years
	Thanks for you suggestions. I have changed filament with no... Dans le forum Others (Archive)	il y a 8 years
	Extrusion failure Dans le forum Others (Archive)	il y a 8 years
	Print Challenge Dans le forum Awesome prints (Hall Of Fame)	il y a 8 years
	Thanks everyone! I feel really dumb. 😳 It was the li... Dans le forum Print tips (Archive)	il y a 8 years
	I can't print Marvin anymore (Mk2) Dans le forum Print tips (Archive)	il y a 8 years
	In an enclosure? No. There is no enclosure, but also no dra... Dans le forum Others (Archive)	il y a 8 years
	Flaky bed temperature Dans le forum Others (Archive)	il y a 8 years
	Good idea. By the way if you are a developer on the Prusa... Dans le forum Improvements (Archive)	il y a 8 years
	For anyone following this thread, there's a happy ending! I... Dans le forum Improvements (Archive)	il y a 8 years
	Initial Z coordinate Dans le forum Prusa i3 kit (Archive)	il y a 8 years
	I used a PT100 temperature table that I found here: to do t... Dans le forum Improvements (Archive)	il y a 8 years
	I have spent quite a bit of time figuring out about PT100 an... Dans le forum Improvements (Archive)	il y a 8 years
	Peter, thanks for the confirmation that I am not alone here.... Dans le forum Software (Archive)	il y a 8 years
	Sorry if I offended anyone. What I observed was a substan... Dans le forum Software (Archive)	il y a 8 years
	Hello, I too am trying to interface a PT100 to the Rambo, bu... Dans le forum Improvements (Archive)	il y a 8 years
	I figured this out. I was using firmware that I built from ... Dans le forum Assembly and first prints troubleshooting	il y a 8 years

Page 1 / 2 Suivant

Statistiques du forum

565 Forums

63.6 K Sujets

446.2 K Messages

22 En-ligne

68.9 K Membres

Le dernier des messages: Xl extruder stops Notre nouveau membre: Kiley Murphy Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé