Aktivität
 
Benachrichtigungen
Alles löschen
bob.s
bob.s
Gruppe: Registriert
Beigetreten: 2016/11/02
Eminent Member
2
Just adding to what nikolai and PJR have stated:.. I get al...

Im Forum Others (Archive)

Vor 6 years
I am trying to figure out the maximum print speed for PLA on...

Im Forum Others (Archive)

Vor 6 years
So, finally getting back to this. I printed mine standing u...

Im Forum Awesome prints (Hall Of Fame)

Vor 8 years
Very helpful. Thank you.

Im Forum Assembly and first prints troubleshooting

Vor 8 years
Thanks for you suggestions. I have changed filament with no...

Im Forum Others (Archive)

Vor 8 years
Extrusion failure

Im Forum Others (Archive)

Vor 8 years
Print Challenge

Im Forum Awesome prints (Hall Of Fame)

Vor 8 years
Thanks everyone! I feel really dumb. 😳 It was the li...

Im Forum Print tips (Archive)

Vor 8 years
I can't print Marvin anymore (Mk2)

Im Forum Print tips (Archive)

Vor 8 years
In an enclosure? No. There is no enclosure, but also no dra...

Im Forum Others (Archive)

Vor 8 years
Flaky bed temperature

Im Forum Others (Archive)

Vor 8 years
Good idea. By the way if you are a developer on the Prusa...

Im Forum Improvements (Archive)

Vor 8 years
For anyone following this thread, there's a happy ending! I...

Im Forum Improvements (Archive)

Vor 8 years
Initial Z coordinate

Im Forum Prusa i3 kit (Archive)

Vor 8 years
I used a PT100 temperature table that I found here: to do t...

Im Forum Improvements (Archive)

Vor 8 years
I have spent quite a bit of time figuring out about PT100 an...

Im Forum Improvements (Archive)

Vor 8 years
Peter, thanks for the confirmation that I am not alone here....

Im Forum Software (Archive)

Vor 8 years
Sorry if I offended anyone. What I observed was a substan...

Im Forum Software (Archive)

Vor 8 years
Hello, I too am trying to interface a PT100 to the Rambo, bu...

Im Forum Improvements (Archive)

Vor 8 years
I figured this out. I was using firmware that I built from ...

Im Forum Assembly and first prints troubleshooting

Vor 8 years
Seite 1 / 2
Teilen: