Notifications
Clear all
bob.s
bob.s
Skupina: Registrovaný
Přidal se: 2016/11/02
Eminent Member
2
Just adding to what nikolai and PJR have stated:.. I get al...

In forum Others (Archive)

před 6 years
I am trying to figure out the maximum print speed for PLA on...

In forum Others (Archive)

před 6 years
So, finally getting back to this. I printed mine standing u...

In forum Awesome prints (Hall Of Fame)

před 8 years
Very helpful. Thank you.

In forum Assembly and first prints troubleshooting

před 8 years
Thanks for you suggestions. I have changed filament with no...

In forum Others (Archive)

před 8 years
Extrusion failure

In forum Others (Archive)

před 8 years
Print Challenge

In forum Awesome prints (Hall Of Fame)

před 8 years
Thanks everyone! I feel really dumb. 😳 It was the li...

In forum Print tips (Archive)

před 8 years
I can't print Marvin anymore (Mk2)

In forum Print tips (Archive)

před 8 years
In an enclosure? No. There is no enclosure, but also no dra...

In forum Others (Archive)

před 8 years
Flaky bed temperature

In forum Others (Archive)

před 8 years
Good idea. By the way if you are a developer on the Prusa...

In forum Improvements (Archive)

před 8 years
For anyone following this thread, there's a happy ending! I...

In forum Improvements (Archive)

před 8 years
Initial Z coordinate

In forum Prusa i3 kit (Archive)

před 8 years
I used a PT100 temperature table that I found here: to do t...

In forum Improvements (Archive)

před 8 years
I have spent quite a bit of time figuring out about PT100 an...

In forum Improvements (Archive)

před 8 years
Peter, thanks for the confirmation that I am not alone here....

In forum Software (Archive)

před 8 years
Sorry if I offended anyone. What I observed was a substan...

In forum Software (Archive)

před 8 years
Hello, I too am trying to interface a PT100 to the Rambo, bu...

In forum Improvements (Archive)

před 8 years
I figured this out. I was using firmware that I built from ...

In forum Assembly and first prints troubleshooting

před 8 years
Stránka 1 / 2
Share: