English
Forums
Members
bjohns029
Activity
 
Notifications
Clear all
bjohns029
bjohns029
Group: Registered
Joined: 2022/02/09
Eminent Member
2
Profile Activity
Wire crimped and how to clean extruder?

In forum Hardware, firmware and software help

 1 year ago
Pattern on bottom of prints

In forum General discussion, announcements and releases

 2 years ago
Ah, I haven’t been keeping up with delays. The picture attac...

In forum General discussion, announcements and releases

 2 years ago
Mini+ Prusa Enclosure?

In forum General discussion, announcements and releases

 2 years ago
Apologies! Trying again.  thinwallissue.zip

In forum How do I print this? (Printing help)

 3 years ago
Thin Wall Perimeter Not Connecting

In forum How do I print this? (Printing help)

 3 years ago
It is a Sunlu heated dryer from Amazon. I am going to do sta...

In forum How do I print this? (Printing help)

 3 years ago
Actually, this is Matter Hackers Build PLA.

In forum How do I print this? (Printing help)

 3 years ago
This is after lowering retraction to 2 mm. Should I change i...

In forum How do I print this? (Printing help)

 3 years ago
Oh, I forgot to mention that! Hatchbox PLA. It is in a filam...

In forum How do I print this? (Printing help)

 3 years ago
Thank you for the reply, will try this on my next print of t...

In forum How do I print this? (Printing help)

 3 years ago
Need Help with Stringing

In forum How do I print this? (Printing help)

 3 years ago
Not sure if the attachment was included?

In forum How do I print this? (Printing help)

 3 years ago
O.8 mm Nozzle Print - Stringing and Thin Walls

In forum How do I print this? (Printing help)

 3 years ago
Nozzle Change

In forum Assembly and first prints troubleshooting

 3 years ago
0.8mm nozzle first layer height

In forum Assembly and first prints troubleshooting

 3 years ago
Issue with bridge infill?

In forum How do I print this? (Printing help)

 3 years ago
New print.  D45B2E61-1EF8-451A-BCEB-0E6A6EB7F7F3.jpe...

In forum Assembly and first prints troubleshooting

 3 years ago
Looks like you read it right. I don't have the best handwrit...

In forum Assembly and first prints troubleshooting

 3 years ago
Here is an updated attempt at calibration. Any tips or recom...

In forum Assembly and first prints troubleshooting

 3 years ago
Page 1 / 2
Share: