Notifiche
Cancella tutti
bhuvanj
Gruppo: Registrato
Registrato: 2017/10/08
Active Member
1
| @komet_82 I would recommend few options, in sequence: - rais... | 5 years fa | |
| can you clarify: - how many filaments printing? - what fila... | 5 years fa | |
| Thanks for support.It did turn out to be a clogged nozzle. L... | 5 years fa | |
| @gerardo-w I’m regards to filament being an issue what or wh... | 5 years fa | |
| @david-a66 Thanks. The printer is open on a desk Ambient tem... | 5 years fa | |
| Printer running "Dry". Stops extruding filament, and keeps r... | 5 years fa | |
|
Thermistor Specs Nel forum Hardware, firmware and software help |
5 years fa | |
|
It's a bit big, ideally Live Z should be under 1mm.
if mem... Nel forum Others (Archive) |
7 years fa | |
|
Thanks Allen,
I adjusted the Pinda and did a factory reset.... Nel forum Others (Archive) |
7 years fa | |
|
Help with first print (MK3 Kit) Nel forum Others (Archive) |
7 years fa |