Notifications
Clear all
bhuvanj
Skupina: Registrovaný
Přidal se: 2017/10/08
Active Member
1
| @komet_82 I would recommend few options, in sequence: - rais... | před 5 years | |
| can you clarify: - how many filaments printing? - what fila... | před 5 years | |
| Thanks for support.It did turn out to be a clogged nozzle. L... | před 5 years | |
| @gerardo-w I’m regards to filament being an issue what or wh... | před 5 years | |
| @david-a66 Thanks. The printer is open on a desk Ambient tem... | před 5 years | |
| Printer running "Dry". Stops extruding filament, and keeps r... | před 5 years | |
|
Thermistor Specs In forum Hardware, firmware and software help |
před 5 years | |
|
It's a bit big, ideally Live Z should be under 1mm.
if mem... In forum Others (Archive) |
před 7 years | |
|
Thanks Allen,
I adjusted the Pinda and did a factory reset.... In forum Others (Archive) |
před 7 years | |
|
Help with first print (MK3 Kit) In forum Others (Archive) |
před 7 years |