Prusa3D Forum

Notifications

Clear all

bgoner

Grupa: Zarejestrowany

Dołączył: 2020/01/03

Active Member

	Unfortunately it's back quite fast. Is this normal when a l... In forum Hardware, firmware and software help	5 years temu
	Definitely PEI has better adhesion It gets better with use.... In forum Hardware, firmware and software help	5 years temu
	We should definitely ask Prusa to include this in the manual... In forum Hardware, firmware and software help	5 years temu
	I think I've fixed it: 1. remove top cover and remove filame... In forum Hardware, firmware and software help	5 years temu
	I'm almost in the same boat. Managed to get it out without c... In forum Hardware, firmware and software help	5 years temu
	Having trouble getting it to stick to do anything calibratio... In forum Hardware, firmware and software help	5 years temu
	I had the same problem at the beginning with the textured be... In forum Hardware, firmware and software help	5 years temu
	When I push the filament on the right, which is the directio... In forum Hardware, firmware and software help	5 years temu
	Squicking noise: failed unwind after filament ended In forum Hardware, firmware and software help	5 years temu

Statystyki Forum

559 Fora

63 K Tematy

443.6 K Posty

19 Online

67.9 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte