Prusa3D Forum

Notifications

Clear all

bgoner

Skupina: Registrovaný

Přidal se: 2020/01/03

Active Member

	Unfortunately it's back quite fast. Is this normal when a l... In forum Hardware, firmware and software help	před 6 years
	Definitely PEI has better adhesion It gets better with use.... In forum Hardware, firmware and software help	před 6 years
	We should definitely ask Prusa to include this in the manual... In forum Hardware, firmware and software help	před 6 years
	I think I've fixed it: 1. remove top cover and remove filame... In forum Hardware, firmware and software help	před 6 years
	I'm almost in the same boat. Managed to get it out without c... In forum Hardware, firmware and software help	před 6 years
	Having trouble getting it to stick to do anything calibratio... In forum Hardware, firmware and software help	před 6 years
	I had the same problem at the beginning with the textured be... In forum Hardware, firmware and software help	před 6 years
	When I push the filament on the right, which is the directio... In forum Hardware, firmware and software help	před 6 years
	Squicking noise: failed unwind after filament ended In forum Hardware, firmware and software help	před 6 years

Fórum Statistiky

595 Fóra

68.8 K Témata

481.2 K Příspěvky

16 Online

77.3 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed