Prusa3D Forum

Notifiche

Cancella tutti

bgoner

Gruppo: Registrato

Registrato: 2020/01/03

Active Member

	Unfortunately it's back quite fast. Is this normal when a l... Nel forum Hardware, firmware and software help	6 years fa
	Definitely PEI has better adhesion It gets better with use.... Nel forum Hardware, firmware and software help	6 years fa
	We should definitely ask Prusa to include this in the manual... Nel forum Hardware, firmware and software help	6 years fa
	I think I've fixed it: 1. remove top cover and remove filame... Nel forum Hardware, firmware and software help	6 years fa
	I'm almost in the same boat. Managed to get it out without c... Nel forum Hardware, firmware and software help	6 years fa
	Having trouble getting it to stick to do anything calibratio... Nel forum Hardware, firmware and software help	6 years fa
	I had the same problem at the beginning with the textured be... Nel forum Hardware, firmware and software help	6 years fa
	When I push the filament on the right, which is the directio... Nel forum Hardware, firmware and software help	6 years fa
	Squicking noise: failed unwind after filament ended Nel forum Hardware, firmware and software help	6 years fa

Statistiche Forum

595 Forum

68.8 K Discussioni

481.2 K Post

13 Online

77.3 K Utenti

Icone forum: Il forum non contiene post non letti Il forum contiene post non letti

Icone discussione: Nessuna Risposta Con risposte Attivo Hot In evidenza Disapprovato Risolto Privato Chiuso