|
Unfortunately it's back quite fast. Is this normal when a l... In forum Hardware, firmware and software help |
5 years ago |
|
Definitely PEI has better adhesion It gets better with use.... In forum Hardware, firmware and software help |
5 years ago |
|
We should definitely ask Prusa to include this in the manual... In forum Hardware, firmware and software help |
5 years ago |
|
I think I've fixed it: 1. remove top cover and remove filame... In forum Hardware, firmware and software help |
5 years ago |
|
I'm almost in the same boat. Managed to get it out without c... In forum Hardware, firmware and software help |
5 years ago |
|
Having trouble getting it to stick to do anything calibratio... In forum Hardware, firmware and software help |
5 years ago |
|
I had the same problem at the beginning with the textured be... In forum Hardware, firmware and software help |
5 years ago |
|
When I push the filament on the right, which is the directio... In forum Hardware, firmware and software help |
5 years ago |
|
Squicking noise: failed unwind after filament ended In forum Hardware, firmware and software help |
5 years ago |