|
More motor issues 🙂 Im Forum Hardware, firmware and software help |
Vor 10 months |
|
To add some doubt to the mix, here is a string connected Cor... Im Forum Hardware, firmware and software help |
Vor 10 months |
|
Here is someone with the Bambu having the same problem. Im Forum Hardware, firmware and software help |
Vor 10 months |
|
Prusa support, after some chasing on live-chat have decided ... Im Forum Hardware, firmware and software help |
Vor 10 months |
|
As much as I can without removing the belt and motor. Not mu... Im Forum Hardware, firmware and software help |
Vor 10 months |
|
Measuring between 39.9mm and 40.1mm at the extremes. So squa... Im Forum Hardware, firmware and software help |
Vor 10 months |
|
Changed filament for now but I've noticed some faces on the ... Im Forum Hardware, firmware and software help |
Vor 10 months |
|
I haven't heard anything from support in a few days again, a... Im Forum Hardware, firmware and software help |
Vor 10 months |
|
I'm back in discussions with support via email, printing yet... Im Forum Hardware, firmware and software help |
Vor 10 months |
|
VFA seems to happen to Bambu printers as well - long posts a... Im Forum Hardware, firmware and software help |
Vor 10 months |
|
I've attached the gcode from Prusa slicer - just make sure y... Im Forum Hardware, firmware and software help |
Vor 11 months |
|
OK belt tension will NOT solve this issue. I've tensioned t... Im Forum Hardware, firmware and software help |
Vor 11 months |
|
Core One Belt tuner gauge not working (Android) Im Forum Known issues and troubleshooting |
Vor 11 months |
|
Ah that's great. I'll give that a go Im Forum Hardware, firmware and software help |
Vor 11 months |
|
In the latest test I've turned off stealth mode and am runni... Im Forum Hardware, firmware and software help |
Vor 11 months |
|
I had a look at the config in the firmware and can see that ... Im Forum Hardware, firmware and software help |
Vor 11 months |
|
Tensioning the belts has helped a reduce VFAs a bit - howeve... Im Forum Hardware, firmware and software help |
Vor 11 months |
|
I touched the belts again, they felt a little bit on the loo... Im Forum Hardware, firmware and software help |
Vor 11 months |
|
I am following that thread. The noise is fine and it's prett... Im Forum Hardware, firmware and software help |
Vor 11 months |
|
VFA Artifacts on X+Y Straight Edges Im Forum Hardware, firmware and software help |
Vor 11 months |
