Aktywność
 
Notifications
Clear all
Bastian
Bastian
Grupa: Zarejestrowany
Dołączył: 2016/08/01
Trusted Member
3
MK2 - PETG is plugging the nozzle 🙁

In forum General discussion, announcements and releases

7 years temu
Upgrade from MK2 to MK2.5

In forum General discussion, announcements and releases

7 years temu
Problem with filament feed

In forum Others (Archive)

7 years temu
Okay, i known that the printer draws a higher mount of amps....

In forum Others (Archive)

8 years temu
DC Connector between PSU and Prusa?

In forum Others (Archive)

8 years temu
Hey, i tuned the Slic3r-Settings for my PETG-preset: So tha...

In forum Print tips (Archive)

8 years temu
Layer bonding PETG not very good?

In forum Print tips (Archive)

8 years temu
Hey there, i've actual the same problem with changing the f...

In forum Print tips (Archive)

8 years temu
Hey Patrik, thanks for your answer. I will test and adjust ...

In forum Print tips (Archive)

8 years temu
Recommendation to print ABS?

In forum Print tips (Archive)

8 years temu
Hey. Update... I got my MK2 calibrated correctly, all seems ...

In forum Others (Archive)

8 years temu
Hmpf. Don't know whats going wrong... got the new bearings t...

In forum Others (Archive)

8 years temu
Hey, i think, i know what the cause of this noise is - the ...

In forum Others (Archive)

8 years temu
I use ESD tweezers to lift up corners - not with the top, bu...

In forum Others (Archive)

8 years temu
Hey Peter, I will give them a try and ordered 12 bearings -...

In forum Others (Archive)

8 years temu
Hi there, i've removed the PSU from the MK2-Frame (and the ...

In forum Others (Archive)

8 years temu
I tried to grease them with WD40 Now, why would a Water Dis...

In forum Others (Archive)

8 years temu
Are you sure? The noise appears not constantly - only on y-a...

In forum Others (Archive)

8 years temu
Loud noise on Y-movement - bearnings?

In forum Others (Archive)

8 years temu
Hey, got it! Had to rotate my Part in AutoDesk 90° - than th...

In forum Print tips (Archive)

8 years temu
Strona 2 / 3
Share: