Actividad
 
Avisos
Vaciar todo
Bastian
Bastian
Grupo: Registrado
Registrado: 2016/08/01
Trusted Member
3
MK2 - PETG is plugging the nozzle 🙁

En el foro General discussion, announcements and releases

hace 7 years
Upgrade from MK2 to MK2.5

En el foro General discussion, announcements and releases

hace 7 years
Problem with filament feed

En el foro Others (Archive)

hace 7 years
Okay, i known that the printer draws a higher mount of amps....

En el foro Others (Archive)

hace 8 years
DC Connector between PSU and Prusa?

En el foro Others (Archive)

hace 8 years
Hey, i tuned the Slic3r-Settings for my PETG-preset: So tha...

En el foro Print tips (Archive)

hace 8 years
Layer bonding PETG not very good?

En el foro Print tips (Archive)

hace 8 years
Hey there, i've actual the same problem with changing the f...

En el foro Print tips (Archive)

hace 8 years
Hey Patrik, thanks for your answer. I will test and adjust ...

En el foro Print tips (Archive)

hace 8 years
Recommendation to print ABS?

En el foro Print tips (Archive)

hace 8 years
Hey. Update... I got my MK2 calibrated correctly, all seems ...

En el foro Others (Archive)

hace 8 years
Hmpf. Don't know whats going wrong... got the new bearings t...

En el foro Others (Archive)

hace 8 years
Hey, i think, i know what the cause of this noise is - the ...

En el foro Others (Archive)

hace 8 years
I use ESD tweezers to lift up corners - not with the top, bu...

En el foro Others (Archive)

hace 8 years
Hey Peter, I will give them a try and ordered 12 bearings -...

En el foro Others (Archive)

hace 8 years
Hi there, i've removed the PSU from the MK2-Frame (and the ...

En el foro Others (Archive)

hace 8 years
I tried to grease them with WD40 Now, why would a Water Dis...

En el foro Others (Archive)

hace 8 years
Are you sure? The noise appears not constantly - only on y-a...

En el foro Others (Archive)

hace 8 years
Loud noise on Y-movement - bearnings?

En el foro Others (Archive)

hace 8 years
Hey, got it! Had to rotate my Part in AutoDesk 90° - than th...

En el foro Print tips (Archive)

hace 8 years
Página 2 / 3
Compartir: