Polski
Fora
Członkowie
Bas
Aktywność
 
Notifications
Clear all
Bas
Bas
Grupa: Zarejestrowany
Dołączył: 2020/01/19
Trusted Member
3
Profil Aktywność
How can I avoid that the unretractions are in the middle of ...

In forum Coronavirus (COVID-19)

 5 years temu
I lowered the speed of support material from the default for...

In forum How do I print this? (Printing help)

 5 years temu
@chocki First of all, thanks for your tips. At the photo abo...

In forum How do I print this? (Printing help)

 5 years temu
I reduced the print speed to 70% and that helped. I will do ...

In forum How do I print this? (Printing help)

 5 years temu
Support material interface is of poor quality, what can I do...

In forum How do I print this? (Printing help)

 5 years temu
Hi Joan, The second layer of the support started and looks v...

In forum How do I print this? (Printing help)

 5 years temu
The first layer of the support has started:

In forum How do I print this? (Printing help)

 5 years temu
attached is the gcode

In forum How do I print this? (Printing help)

 5 years temu
attached is the gcode

In forum How do I print this? (Printing help)

 5 years temu
Hi, Some first drops off filament occur now on the support. ...

In forum How do I print this? (Printing help)

 5 years temu
So far so good. A tiny bit of filament collected around the ...

In forum How do I print this? (Printing help)

 5 years temu
Hi Joan, Here is a photo of the print running:

In forum How do I print this? (Printing help)

 5 years temu
Hi, The new testprint with 0.95 extrusion multiplier is runn...

In forum How do I print this? (Printing help)

 5 years temu
Thanks Joan, I will try and come back.

In forum How do I print this? (Printing help)

 5 years temu
Blob half way my print, how can I avoid this?

In forum How do I print this? (Printing help)

 5 years temu
Difference between website and manual, Pinda probe height wh...

In forum Assembly and first prints troubleshooting

 5 years temu
Strona 3 / 3
Share: