Čeština
Fóra
Uživatelé
Bas
Aktivita
 
Notifications
Clear all
Bas
Bas
Skupina: Registrovaný
Přidal se: 2020/01/19
Trusted Member
3
Profile Aktivita
How can I avoid that the unretractions are in the middle of ...

In forum Coronavirus (COVID-19)

 před 5 years
I lowered the speed of support material from the default for...

In forum How do I print this? (Printing help)

 před 5 years
@chocki First of all, thanks for your tips. At the photo abo...

In forum How do I print this? (Printing help)

 před 5 years
I reduced the print speed to 70% and that helped. I will do ...

In forum How do I print this? (Printing help)

 před 5 years
Support material interface is of poor quality, what can I do...

In forum How do I print this? (Printing help)

 před 5 years
Hi Joan, The second layer of the support started and looks v...

In forum How do I print this? (Printing help)

 před 5 years
The first layer of the support has started:

In forum How do I print this? (Printing help)

 před 5 years
attached is the gcode

In forum How do I print this? (Printing help)

 před 5 years
attached is the gcode

In forum How do I print this? (Printing help)

 před 5 years
Hi, Some first drops off filament occur now on the support. ...

In forum How do I print this? (Printing help)

 před 5 years
So far so good. A tiny bit of filament collected around the ...

In forum How do I print this? (Printing help)

 před 5 years
Hi Joan, Here is a photo of the print running:

In forum How do I print this? (Printing help)

 před 5 years
Hi, The new testprint with 0.95 extrusion multiplier is runn...

In forum How do I print this? (Printing help)

 před 5 years
Thanks Joan, I will try and come back.

In forum How do I print this? (Printing help)

 před 5 years
Blob half way my print, how can I avoid this?

In forum How do I print this? (Printing help)

 před 5 years
Difference between website and manual, Pinda probe height wh...

In forum Assembly and first prints troubleshooting

 před 5 years
Stránka 3 / 3
Share: