Bas – Activité – Prusa3D Forum

Notifications

Clear all

Bas

Groupe: Enregistré

A(ont) rejoint: 2020/01/19

Trusted Member

	How can I avoid that the unretractions are in the middle of ... Dans le forum Coronavirus (COVID-19)	il y a 5 years
	I lowered the speed of support material from the default for... Dans le forum How do I print this? (Printing help)	il y a 5 years
	@chocki First of all, thanks for your tips. At the photo abo... Dans le forum How do I print this? (Printing help)	il y a 5 years
	I reduced the print speed to 70% and that helped. I will do ... Dans le forum How do I print this? (Printing help)	il y a 5 years
	Support material interface is of poor quality, what can I do... Dans le forum How do I print this? (Printing help)	il y a 5 years
	Hi Joan, The second layer of the support started and looks v... Dans le forum How do I print this? (Printing help)	il y a 5 years
	The first layer of the support has started: Dans le forum How do I print this? (Printing help)	il y a 5 years
	attached is the gcode Dans le forum How do I print this? (Printing help)	il y a 5 years
	attached is the gcode Dans le forum How do I print this? (Printing help)	il y a 5 years
	Hi, Some first drops off filament occur now on the support. ... Dans le forum How do I print this? (Printing help)	il y a 5 years
	So far so good. A tiny bit of filament collected around the ... Dans le forum How do I print this? (Printing help)	il y a 5 years
	Hi Joan, Here is a photo of the print running: Dans le forum How do I print this? (Printing help)	il y a 5 years
	Hi, The new testprint with 0.95 extrusion multiplier is runn... Dans le forum How do I print this? (Printing help)	il y a 5 years
	Thanks Joan, I will try and come back. Dans le forum How do I print this? (Printing help)	il y a 5 years
	Blob half way my print, how can I avoid this? Dans le forum How do I print this? (Printing help)	il y a 5 years
	Difference between website and manual, Pinda probe height wh... Dans le forum Assembly and first prints troubleshooting	il y a 5 years

Page 3 / 3 Précédent

Statistiques du forum

565 Forums

63.6 K Sujets

446.2 K Messages

19 En-ligne

68.9 K Membres

Le dernier des messages: Repeated Probing on right side of bed Notre nouveau membre: Kiley Murphy Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé