Notifications
Clear all
Barry Jindra
Grupa: Zarejestrowany
Dołączył: 2022/05/28
Active Member
1
| Mini corners. | 3 weeks temu | |
| I went from 3.5 to 3.9s. All parts and assembly went good. D... | 4 weeks temu | |
| I went from 3.5 to 3.9s. All parts and assembly went good. D... | 4 weeks temu | |
|
I knew it was in there somewhere, I have seen it before but ... In forum Hardware, firmware and software help |
1 year temu | |
|
Loading too much filament to hot end In forum Hardware, firmware and software help |
1 year temu | |
|
I updated to 3.13.2 and now my sd card is not reading either... In forum Hardware, firmware and software help |
2 years temu | |
| downloaded and flashed printer fine. did the calibration and... | 2 years temu | |
| Where did you find the HEX files for 3.13.2? I am at 3.13.0 ... | 2 years temu | |
|
Will not load filament into extruder In forum Hardware, firmware and software help |
4 years temu |